Drone Traceboard

The Seahorse Drone Traceboard is designed with Drone fishers in mind.

It holds the 500mm long Seahorse Drone Traces making it 300mm shorter than the standard Seahorse Traceboard.

The Drone Traceboard is 300mm shorter than the standard Seahorse Traceboard and it holds traces 500mm long. The traces have tubes on them to reduce twisting and tangling as the drone flies the baits out to Sea. The traces have longline clips which are easy to clip on and remove the traces from the looped line.

The traceboard comes with 26 tube traces.

The 6oz breakaway sinkers also have longline clips and a swivel. It is recommended to place a rubber band around the breakaway spikes to increase the breakaway pressure. This will allow the line to be pulled tight from the weights back to the winch.

Set-up for Launching

With the speed of the drone, you need to have everything set up before you take off. Some people stretch the hook section of line up and down the beach, but the seagulls will attack your baits and get everything tangled. It is best to lay the traces out side by side with the polyester line looping away from the traces. With liftoff, the traces will then be lifted up into the air by the drone, not dragged across the beach from where they were laying to where the drone is.

As the baits start lifting into the sky, you can start flying the drone forward (and up), but care is needed to ensure the line comes off the winch at a consistent speed.